Buttons have a wide range of applications, especially ordinary ones. Some of the clothes we wear look at so many beautiful buttons. Many people want to know how buttons are made in the end. Here are the tips of the small button maker to discuss the process of button making and some related precautions. 1) The surface shape of the button, in the shape of the button, most of them are hand-grinding styling knives. The disadvantage is that the same shape, the same model, when the number is large, the shape easily run away, which depends on the responsibility of the buckle technician Responsible and qualified technicians can do a good job. Then there is a sharpening machine. If the number is large, it will be very good and it will not run. However, when setting up the knife, it is also necessary to pay attention to the distance between the surface and the left and right sides. The tool holder is not very delicate and has clearance.
2) The thickness of the edge of the button, the edge of a button is not noticed, the same batch of goods are thick and thin, there is no unified, this is related to the responsibility of the deduction machine chuck and technician, when the chuck adjustment Generally, I saw the buckle technicians in the deduction factory. After adjusting the outside of the machine, after installing the machine, most of them did not adjust. In fact, although the collet has been adjusted, after the machine is installed, it still needs to be adjusted. , because -1) Did you have the grease on the chuck when you mounted it? 2) Isn't there any error in your part of the machine's chuck?
3) Do you have any dirt on the part of the machine that you are loading? Therefore, even if the clip head is installed, it is still necessary to be responsible for the uniform thickness of each button, and adjustments are required to be adjusted so that the thickness of the buttons can be unified. When the button is installed, the unit is OK and the buttons are adjusted (thickness, edge, shape, eye distance). When you start production, please put a few OKs next to the button machine, because these buttons are It is often the case that large goods are produced at a later time. When starting to produce large goods, these buttons are used to come to an end. When deductions are made, buttons are often used to see the buttons. When a caliper is used, the quantity is compared to ensure that each The quality of a batch of buttons.
4) The tool used to make the deduction, it depends on the responsibility of the deduction technician, and the general deduction technician is lazy. It does not seem to be his own, but it is too late, and it is too late. Grind it, hey, now How many people like this, ah, buckle technicians to look at the buttons in the system, found that the tool is blunt, immediately sharpen the knife, the button to do too hair, then affect the overall quality of buttons, and beautiful, and may become obsolete. There are also requirements for the scraping of the buttons, and the low scraping should also be controlled. Do not scratch it. The low arc must follow suit.
During the deduction process, we must look more, use more calipers, compare the appearance of the calipers, and find that the problem is immediately resolved. Do not wait until the button reaches the finished product. Only after the problem is discovered, what is late? , wasting manpower, financial resources, and delivery date.
Want to learn more about buttons: accessible
Colorful Imitation Nylon Webbing,Webbing Seat Belt,Webbing Stripe Bag Strap,Nylon Webbing For Belts
GuangZhou JinSha Textile Co.,Ltd , https://www.jinshatextile.com